The hand held concrete vibrator is commonly seen on the modern construction site where there are densely-spaced rebars in the concrete and the working area is long but narrow. In such case, large vibrator just reaches its limit. However, utilizing our hand held concrete vibrator could eliminate all those technical headaches.

The product is well suited for use to tamp poured ring beam, concrete pedestal, and concrete foundation. It removes air pockets from the concrete, increasing concrete density while saving the amount of concrete. It also makes sure the concrete is evenly poured onto the rebar framework, thus improving the strength of the whole construction. Additionally, using our vibrator to tighten the concrete can shorten the concrete setting time, thereby expediting the project.

Maintenance and Repair
1. Do not leave the vibrator idling for long hours.
2. At the start of each work shift, the motor exterior needs to be checked for any dirt in order to ensure the motor can disperse heat quickly.
3. Check the motor regularly for loose seal or bad insulation. In the event of the motor incurring moisture damage, it needs to be dried.
4. Replace the bearing periodically. Be sure to clean the bearing and apply new lubricating oil to it on a regular basis.
5. Check other parts for any damage. Upon discovery of any parts problem, solve it immediately.

Features
1. Lightweight structural design gives ease of operation.
2. Double-layer insulations for the motor ensure safe operation.
3. The vibrator uses the single phase motor to supply power. It is suitable for individual use.

Related Names
Electric Vibrating Motor | Concrete Finishing Tools | Construction Power Tools